26-12-2020, 17:06
Guten Abend,
nach dem die Flacheisen eingepasst waren, habe ich jeweils da wo die einzelnen Flacheisen zusammen treffen, ein 1mm Loch durch die MDF Platte gebohrt. Danach alle Flacheisen wieder entfernt und von unten die Löcher für die Flacheisenverbinder gebohrt.
Nun geht es weiter mit dem einpressen der Flacheisen in die Schlitze.
Gruss
Urs
nach dem die Flacheisen eingepasst waren, habe ich jeweils da wo die einzelnen Flacheisen zusammen treffen, ein 1mm Loch durch die MDF Platte gebohrt. Danach alle Flacheisen wieder entfernt und von unten die Löcher für die Flacheisenverbinder gebohrt.
Nun geht es weiter mit dem einpressen der Flacheisen in die Schlitze.
Gruss
Urs