17-01-2020, 11:29
(16-01-2020, 19:04)Haddock schrieb: Hebi:Sind das HSS-Fräser, oder gibt es im 2mm-Bereich inzwischen Besseres?Danke Urs,
- Ich fräse mitt VHM-Schaftfräser (Voll-Hartmetall), also ja!
Hebi: Gibt es deiner Erfahrung nach Unterschiede zwischen MDF- und Tischlerplatten beim Fräsen mit solch dünnen Fräsern?
-Jawoll da gibt es Unterschiede. MDF zerspahnt in Staub, der setzt sich in der Fräsbahn nicht so sehr fest und die Gefahr eines Fräserbruchs ist nicht so hoch. Bei einer Tischlerplatte jedoch ist das anders. Die zerspahnt in echte Späne, welche sich in der Fräsbahn besser fest setzen können und somit die Gefahr eines Fräserbruchs höher ist. Gerade bei so kleinen durchnmessern der Fräser.
Gruss
Urs
hast mir sehr geholfen meine damaligen Probleme einzuordnen!
LG
Hebi
"... beim Beschleunigen müssen die Tränen der Ergriffenheit waagerecht zum Ohr abfließen" Walter Röhrl
- Wer später bremst, fährt länger schnell -
- Wer später bremst, fährt länger schnell -