15-01-2020, 16:08
(14-01-2020, 11:37)Haddock schrieb: ... muss ich mich in Geduld üben und auf die Flacheisen warten...das ist keine Stärke von mir!Hallo Urs,
Gruss
Urs
kann dich ja solange ein bisschen beschäftigen mit ein paar Fragen ...
Ich hatte (vor einigen Jahren) auf meiner Anlage einige Schlitze im Boxenbereich gefräst, nur zu Plazierung von den Slotcars, damit sie dort nicht so unschön auf ihren Führungsstiften stehen müssen.
Zu dem Zeitpunkt hatte ich nur eine Handfräse mit einer festen Drehzahl von 32000U/min. Meine Befürchtungen wegen der sehr hohen Drehzahl wurden leider schnell bestätigt, damit sind mir beim Fräsen (in Tischlerplatte) alle 2mm Fräser sehr schnell verglüht.
Meine Fragen:
Welche Drehzahl verwendest du?
Sind das HSS-Fräser, oder gibt es im 2mm-Bereich inzwischen Besseres?
Du hast auf deiner Bahn (nach meinem Eindruck) in jeder Kurve, von Kurvenanfang bis Kurvenende, immer den gleichen Radius. Wäre es mit deiner Steuerung nicht auch möglich gewesen, sich verengende oder öffnende Kurven zu bauen? (auf deinen ersten Entwürfen sah für mich zumindest so aus)
Gibt es deiner Erfahrung nach Unterschiede zwischen MDF- und Tischlerplatten beim Fräsen mit solch dünnen Fräsern?
LG und wünsche weiter nur Freude und Gelingen
Hebi
"... beim Beschleunigen müssen die Tränen der Ergriffenheit waagerecht zum Ohr abfließen" Walter Röhrl
- Wer später bremst, fährt länger schnell -
- Wer später bremst, fährt länger schnell -