17-12-2019, 21:46
Ich hätte bei dem Layout etwas Sorgen in den sehr engen Kurven. Der Kurven(Slot)radius sollte meiner Meinung nach nicht unter 10 cm sein. Darunter wird es hakelig. Und den Slot würde ich auch ruhig 6 mm tief fräsen, dann bleibt der Pin da nicht drin hängen. Und auf die Spurverengungen würde ich auch verzichten, gibt nur Unfälle.
Aber schön, dass du so ein Projekt angehst. Ich bau ja auch gerne Bahnen...
Aber schön, dass du so ein Projekt angehst. Ich bau ja auch gerne Bahnen...
Der wahrhaft Weise muss ab und zu die gespannte Schärfe seines Geistes lockern - und eben das geschieht durch spielerisches Tun und Denken. (Thomas von Aquin)